When using stainless steel high viscosity gear pumps, if you ignore some common problems, it will directly affect the work and life of the pump. You must pay attention to these when using stainless steel high viscosity gear pumps: The pipe diameter of the inlet and outlet pipelines must be the same. The design of the pipeline should minimize the elbow, and the angle of the elbow should not be too small, and the inlet pipeline should not be too long, so as not to affect the self-priming. Each filling cup should be added before starting Lubricating oil, and ensure to refuel once a day. Before the pump works, start the motor and observe whether the steering of the stainless steel high-viscosity gear pump is consistent with the specified steering. After starting, observe whether the stainless steel high-viscosity gear pump is running normally. If there is abnormal noise, In case of special vibration or excessive temperature rise, etc., it should be shut down and checked. Pay attention to the belt pulley SS high viscosity pump should check whether the belt tension is appropriate, and adjust it every six months.
